Boat indicators

Assemble an electrical monitoring system using these analog, panel mount meters. Meters are available with 2-1/2″ and 3-1/2″ face sizes. Easy to read graphics with unit divisions give precise readouts at a glance. Designed for front panel ...

... modernizes traditional marine gauges. Featured is the R3 - Round 3" touch display, but the range also includes, Standard 3.5" button displays and Slimline 5" or 7" touch displays. All displays feature color screens, ...

... Ideal for boaters who only require key data. Don’t need expensive over complicated systems. Moving Card Compass Indicator Shows heading on a moving compass card Clear ‘at a glance’ analogue display Intuitive, ...

Power supply: 12 V

Dial gauge showing the fuel level. Available in 12 V.

Power supply: 12, 24, 48 V
Diameter: 59 mm

This manager is easy to install, thanks to its round format. It provides access to all the information needed to accurately monitor the status of the electrical system. It calculates the residual capacity and gives visibility on the voltage ...

... NT920RTU). All Indicator heads (NT920RAI) are electrically and mechanically identical (no master / slave distinction) which provides complete interchangeability and straightforward system expansion. Each Indicator ...

Provides Colour Display for all the following devices on an NMEA2000® network: Sunlight readable dimmable display using our BlackGlass™ technology Two direct J1939 interfaces and one NMEA2000© interface Remote button panel providing: ...

Power supply: 12 V - 40 V
Operating temperature: -10 °C - 70 °C

... of interfacing. A+T analogue displays are available in AWS, AWA360, AWA Magnified Wind, TWA360, TWD, TWs, Rudder Angle, Boat Speed, Depth and Tachometer.

Power supply: 15 V
Operating temperature: -30 °C - 80 °C

The EX-1 continually displays the exhaust gas temperature in wet exhaust systems giving advanced warning of potential problems. The EX-1 measures the exhaust gas temperature directly and displays it in degrees centigrade or Fahrenheit. ...

Power supply: 110, 220, 24 V
Operating temperature: -15 °C - 55 °C

Rudder angle indication system AD80 is used to accurately and real timely indicate the direction and position of the rudder in wheel house, ECC room and steering gear room for the crew. With the functions of flexible configuration, ...

Power supply: 12 V - 30 V

PICO, digital panel meters, red, green or blue Led 3 digit-display The PICO line is made of a range of digital indicators with a three-digit red, green or blue display. Reliable and accurate. Made for installation in ...

The A60 Digital Amps Gauge provides accurate low cost digital instrumentation for amps. You can program the gauge to work with a 5.0 to 900 amp shunt (available seperately). Five levels of backlighting can be selected and all set-up and ...

... cureent loads present in many ammeter applications, ammeters must be wired with wire not lighter than 10 AWG approved for Marine use.

Imagine a console that can provide you with a complete view of your boat or vehicles performance. Livorsis Vantage View does just that. Vantage View instruments display real-time performance data and compiles the information ...

... Constant monitoring of rudder angle from 0 to 45 degrees Repeater units are available for multiple station readouts Protects your boat at docking and close maneuvering Any model can be special ordered with longer wire ...

Simple 4-wire connection from shunt Meter senses and powers from shunt connection Includes DC shunt Backlit meter face (separate 12 or 24V DC backlight connections)

Guage kit for CMC Power Lift and T-H Hydro-Jacker hydraulic plates

... Alarm or Shutdown status. Active and Stored Fault messages display the SPN (Suspect Parameter Number), FMI (Failure Mode Indicator) and the OC (Occurrence Count) using the SAE J1939 protocol. The PV25 displays up to ...

SF-S Individual Flat Rocker Switch for SAF-S (Single Station Only) SF-NS Individual Flat Rocker Switch for SAF-NS (Dual Station) SB-S Individual Lever Handle Rocker Switch for SAF-S (Single Stations Only)

Balmar’s Expandable, Next Generation Monitor Learns & Displays All Critical Battery Parameters State of Charge (SoC%) State of Health (SoH%) Charge/Discharge Current Flow Time Remaining History, Faults & Alerts Support for All ...

Specifications Application Ampere Meter Power 12V or 24V Scale Calibration 50A or 80A

Tek-Tanks electrical water senders and gauges are fitted as original equipment by most major UK boat builders. Made from a stainless steel head assembly with a stainless steel tube, they are reliable and easy to install. ...

Rudder angle indicator RVL Rudder angle indicator with dimmer.