RAPID STRUCTURAL ADHESIVE
¬ Fast clamp time, high strength, structural adhesive
¬ Gels in 10 minutes, solid in 2 hours,
¬ Good degree of cure after 6 hours at ambient
¬ Sag resistance of 14mm at 20°C
¬ Available in 400ml 2 component dual cartridges
INTRODUCTION
Spabond™ 730 is a fast curing structural adhesive designed for applications where reduced clamp times are important. It has a simple 1:1 by weight and volume mix ratio.
It can be used to bond together a wide variety of dissimilar materials and has been designed to give a durable high strength bond. Spabond™ 730 is available in cartridges.
TRANSPORT & STORAGE
The resin and hardeners should be kept in securely closed containers during transport and storage. Any accidental spillage should be soaked up with sand, sawdust, cotton waste or any other absorbent material. The area should then be washed clean (see appropriate Safety Data Sheet). Adequate long term storage conditions will result in a shelf life of 1 year for both the resin and hardeners. Storage should be in a warm dry place out of direct sunlight and protected from frost. The storage temperature should be kept constant between 10°C and 25°C, cyclic fluctuations in temperature can cause crystallization. Containers should be firmly closed. Hardeners, in particular, will suffer serious degradation if left exposed to air.